Today Yinuo wants to share with you what are the good ways to save energy in the steel rolling furnace:

1. Improve the combustion process and the fuel is reasonable and fully burned. Because the fan capacity of the milk steel heating furnace is generally too large in the past, and the manual gate adjustment of the air volume is restricted by the production conditions and the labor intensity of the furnace personnel, there is an unsatisfactory air pressure and air volume adjustment Circumstances caused the fuel to not be combusted reasonably and fully, which affected the utilization rate of the fuel. We have made technical improvements to the air supply and oil supply system and added a supporting frequency conversion control system. The furnace worker adjusts the air supply and oil supply through the electronic control system according to the actual production situation. The production rhythm changes, thus reducing the stickiness. The steel oxide scale is too thick. According to calculations, after this transformation, the oxidation burn loss can be reduced by 5, with an annual output of 1.5 million steel, which can create economic benefits of nearly 15 million yuan a year, and all investment in the technical transformation can be recovered in less than 3 months. We have also made appropriate modifications to the atomization nozzle structure, which has clearly improved the atomization of the burner; at the same time, all the fuel is preheated to increase the thermal response capacity. Through these few technical innovations with relatively small investment, the fuel combustion efficiency reached 95 or more, and considerable economic benefits were obtained; in addition, due to the reduction of fuel consumption and exhaust emissions, good social benefits were also obtained.

2. Improve the bottom structure of the furnace and change the heat transfer effect. We formulate a reasonable heating temperature system according to the production process conditions to facilitate the heat transfer of the billet. The choke beam and bottom wall are used in the section heating furnace to ensure the temperature range of each section and improve the radiation efficiency of refractory materials. In the preheating section of the steel billet, the flat-bottomed structure of the stove was changed, and the hump structure was adopted to enhance the hot flue gas to the billet Zhangjiagang City 2156283. The water pipe packaging and supporting structure were changed to reduce heat loss. In the past, the water pipes in the furnace were mostly packed with single-layer wrapping bricks. The high temperature shock resistance is not good, and it is easy to fall off, and the thermal insulation is also poor. It is estimated that the heat loss caused by the water pipe in the furnace accounts for about 1215 of the total heat, and the energy consumption is relatively serious.

For this reason, the method of wrapping water pipes in the furnace was improved, and the composite wrapping was adopted. Although the new dressing method has increased the difficulty of construction, it has extended the service life of the water pipe from the original 2, 3 months to 1 year, and has better thermal insulation, which reduces the heat taken away by the cooling water.

3. Use waste heat to increase air temperature and reduce fuel consumption. Cooling air into the heating furnace drum will lower the temperature in the furnace and increase energy consumption. We use the flue gas temperature to increase the air temperature to 300 through the heat exchanger, which can reduce fuel consumption by 2.5 compared with blowing cold air. At the same time, the waste heat of the heat exchanger can be used to heat the atomized heavy oil and cool the make-up water, which can produce better energy-saving effects.

4. Recycling of waste rolls. Analyze all kinds of scrapped rolls, and screen the rolls that can be reformed. In order to use waste rolls, fully tap the potential benefits of waste rolls and prolong the service life of rolls. Different types of rolls will be used in different stages. With the same external dimensions, waste rolls with different cross-sections can be re-arranged reasonably and cleverly, and transformed into other types of rolls to achieve multi-use and reuse of rolls to reduce roll consumption. Rolls are an important tool in the process of rolling steel. The quality is closely related; rolls are also the main consumable parts. In the total variable cost of the steel rolling workshop, the cost of the rolls is up to 6. Therefore, the level of roll consumption directly affects the production cost of the milk steel workshop.